Security Configuration Command Set
Configuring 802.1X Authentication
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-19
14.3.2.2 show dot1x auth-config
Use this command to display 802.1X authentication configuration settings for one or more ports.
show dot1x auth-config [authcontrolled-portcontrol] [keytxenabled]
[maxreq] [quietperiod] [reauthenabled] [reauthperiod] [servertimeout]
[supptimeout] [txperiod] [port-string]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Only.
Command Alternative (v3.xx.xx and higher)
• show eapol (Section 14.3.2.7)
Command Defaults
• If no parameters are specified, all 802.1X settings will be displayed.
• If port-string is not specified, information for all ports will be displayed.
authcontrolled-
portcontrol
(Optional) Displays the EAPOL port control mode.
keytxenabled (Optional) Displays the state of 802.1X key transmission.
maxreq (Optional) Displays the value set for maximum requests.
quietperiod (Optional) Displays the value set for quiet period.
reauthenabled (Optional) Displays the state of reauthentication control.
reauthperiod (Optional) Displays the value set for reauthentication
period.
servertimeout (Optional) Displays the server timeout value.
supptimeout (Optional) Displays the authentication supplicant timeout
value.
txperiod (Optional) Displays the transmission period value.
port-string (Optional) Displays information for specific port(s). For a
detailed description of possible port-string values, refer to
Section 4.1.2.
To Next Page
Loading...
Need help?
General