Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-51
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the span guard timeout to 300 seconds:
6.2.2.20 show spantree spanguardlock
Use this command to display the span guard lock status of one or more ports.
show spantree spanguardlock port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Matrix>clear spantree spanguardtimeout
port-string Specifies the port(s) for which to show span guard lock
status. For a detailed description of possible port-string
values, refer to Section 4.1.2.
To Next Page
Loading...