Security Configuration Command Set
Configuring 802.1X Authentication
14-24 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14.3.2.6 clear dot1x auth-config
Use this command to reset 802.1X authentication parameters to default values on one or more ports.
clear dot1x auth-config [authcontrolled-portcontrol] [keytxenabled] [maxreq]
[quietperiod] [reauthenabled] [reauthperiod] [servertimeout] [supptimeout]
[txperiod] [port-string]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
• If no parameters are specified, all authentication parameters will be reset.
• If port-string is not specified, parameters will be set on all ports.
authcontrolled-
portcontrol
(Optional) Resets the 802.1X port control mode to auto.
keytxenabled (Optional) Resets the 802.1X key transmission state to
disabled (false).
maxreq (Optional) Resets the maximum requests value to 2.
quietperiod (Optional) Resets the quiet period value to 60 seconds.
reauthenabled (Optional) Resets the reauthentication control state to
disabled (false).
reauthperiod (Optional) Resets the reauthentication period value to 60
seconds.
servertimeout (Optional) Resets the server timeout value to 30 seconds.
supptimeout (Optional) Resets the authentication supplicant timeout
value to 30 seconds.
txperiod (Optional) Resets the transmission period value to 30
seconds.
port-string (Optional) Resets settings on specific port(s). For a
detailed description of possible port-string values, refer to
Section 4.1.2.
To Next Page
Loading...
Need help?
General