Process Overview: Routing Protocol Configuration
Configuring RIP
13-2 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
13.1.1 Configuring RIP
Purpose
To enable and configure the Routing Information Protocol (RIP).
RIP Configuration Task List and Commands
Table 13-1 lists the tasks and commands associated with RIP configuration. Commands are
described in the associated section as shown.
NOTE: Enabling RIP with the router rip and network commands is required if you
want to run RIP on the device. All other tasks are optional.
Table 13-1 RIP Configuration Task List and Commands
To do this... Use these commands...
Enable RIP configuration mode and
associate a network.
router rip (Section 13.1.1.1)
network (RIP) (Section 13.1.1.2)
Allow unicast updates by defining a
neighboring router.
neighbor (RIP) (Section 13.1.1.3)
Configure an administrative distance. distance (Section 13.1.1.4)
Apply offsets to RIP routing metrics. ip rip offset (Section 13.1.1.5)
Adjust timers. timers (Section 13.1.1.6)
Specify a RIP version. ip rip send version (Section 13.1.1.7)
ip rip receive version (Section 13.1.1.8)
To Next Page
Loading...
