Enterasys 1G58x-09 - Set Spantree Adminpoint

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-55
Command Mode
Read-Only.
Example
This example shows how to display the point-to-point status of the LAN segment attached to Fast
Ethernet front panel port 3:
6.2.2.26 set spantree adminpoint
Use this command to set the administrative point-to-point status of the LAN segment attached to a
Spanning Tree port.
set spantree adminpoint port-string {true | false | auto}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>show spantree adminpoint fe.0.3
admin point-to-point = AUTO for port fe.0.3
port-string Specifies the port(s) for which to set point-to-point protocol
status. For a detailed description of possible port-string
values, refer to Section 4.1.2.
true | false | auto Specifies the point-to-point status of the LAN attached to
the specified port.
• true forces the port to be considered point-to-point.
• false forces the port to be considered non point-to-point.
• auto (the default setting) allows the firmware to
determine the port’s point-to-point status.