Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-9
6.2.1.2 set spantree
Use this command to globally enable or disable the Spanning Tree protocol on the switch.
set spantree {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Max Hops Spanning Tree maximum hop count. Default of 20
can be changed using the set spantree maxhops
command, as described in Section 6.2.1.39.
SID Spanning Tree ID.
Port Spanning Tree port designation. For a detailed
description of possible port-string values, refer to
Section 4.1.2.
State Spanning Tree port state (listening, learning,
forwarding or blocked).
Role Whether the port’s Spanning Tree role is root,
designated, backup, alternate, disabled or master.
Cost Cost value assigned to the port.
Priority Port’s Spanning Tree priority.
disable | enable Globally disables or enables Spanning Tree.
Table 6-1 show spantree stats Output Details (Continued)
Output What It Displays...
To Next Page
Loading...
Need help?
General