Enterasys 1G58x-09 - Clear Port Priority

Port Priority and Classification Configuration Commands
Configuring Port Priority
9-6 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set a default priority of 6 on Fast Ethernet front panel port 3. Frames
received by port 3 without priority information in their frame header are set to the default setting
of 6:
9.3.1.3 clear port priority
Use this command to reset the current 802.1D port priority setting to 0. This will cause all frames
received without a priority value in its header to be set to priority 0.
clear port priority port-string
Syntax Description
Command Defaults
None.
port-string Specifies the port for which to set priority. For a detailed
description of possible port-string values, refer to
Section 4.1.2.
priority Specifies an 802.1D port priority. Valid values are 0 - 7,
with 0 as the lowest priority.
Matrix>set port priority fe.0.3 6
port-string Specifies the port for which to clear priority. For a detailed
description of possible port-string values, refer to
Section 4.1.2.