Enterasys 1G58x-09 - Setting the Host VLAN; Show Host Vlan

VLAN Configuration Command Set
Setting the Host VLAN
7-38 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
7.3.6 Setting the Host VLAN
Purpose
To configure a host VLAN that only select devices are allowed to access. This secures the host port
for management-only tasks.
Commands
The commands needed to configure host VLANs are listed below and described in the associated
section as shown.
• show host vlan (Section 7.3.6.1)
• set port vlan host (Section 7.3.6.2)
• clear host vlan (Section 7.3.6.3)
7.3.6.1 show host vlan
Use this command to display the current host VLAN.
show host vlan
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
NOTE: The host port is the management entity of the device.