Security Configuration Command Set
Configuring 802.1X Authentication
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-21
14.3.2.4 set dot1x auth-config
Use this command to configure 802.1X authentication.
set dot1x auth-config {[authcontrolled-portcontrol {auto | forced-auth |
forced-unauth}] [keytxenabled {false | true}] [maxreq value] [quietperiod
value] [reauthenabled {false | true}] [reauthperiod value] [servertimeout
timeout] [supptimeout timeout] [txperiod value]} port-string
Syntax Description
authcontrolled-
portcontrol auto |
forced-auth |
forced-unauth
Specifies the EAPOL port control mode as:
• auto - Auto authorization mode. This is the default mode
and will forward frames according to the authentication
state of the port. For details on this mode, refer to
Table 14-2.
• forced-auth - Forced authorized mode, which disables
authentication on the port.
• forced-unauth - Forced unauthorized mode, which
filters and discards all frames received on the port.
keytxenabled
false | true
Enables (true) or disables (false) 802.1X key transmission.
maxreq value Specifies the maximum number of authentictation requests
allowed. Valid values are 1 - 2147483647.
quietperiod value Specifies the time (in seconds) following a failed
authentication before another attempt can be made. Valid
values are 1 - 2147483647.
reauthenabled
false | true
Enables (true) or disables (false) reauthentication control.
reauthperiod
value
Specifies the time lapse (in seconds) between attempts to
reauthenticate a port. Valid values are 1 - 2147483647.
servertimeout
timeout
Specifies a timeout period (in seconds) for the
authentication server. Valid values are 1 - 2147483647.
To Next Page
Loading...