Port Configuration Command Set
Reviewing Port Status
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 4-7
4.3 PORT CONFIGURATION COMMAND SET
4.3.1 Reviewing Port Status
Purpose
To display port operating status, duplex mode, speed and port type, and statistical information about
traffic received and transmitted through one port or all ports on the device.
Commands
The commands needed to review port status are listed below and described in the associated
sections as shown.
• show port status (Section 4.3.1.1)
• show port counters (Section 4.3.1.2)
• clear port counters (Section 4.3.1.3)
4.3.1.1 show port status
Use this command to display duplex mode, speed and port type, and statistical information about
traffic received and transmitted through one or more ports on the device.
show port status [port-string]
Syntax Description
Command Defaults
If port-string is not specified, status information for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
port-string (Optional) Displays status for specific port(s). For a
detailed description of possible port-string values, refer to
Section 4.1.2.
To Next Page
Loading...
Need help?
General