VLAN Configuration Command Set
Enabling/Disabling GVRP (GARP VLAN Registration Protocol)
7-48 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
7.3.8.4 set garp timer
Use this command to adjust the values of the join, leave, and leaveall timers.
set garp timer {[join timer_value] [leave timer_value] [leaveall timer_value]}
port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the GARP join timer value to 100 centiseconds for all the ports on
all the VLANs:
NOTE: The setting of these timers is critical and should only be changed by personnel
familiar with the 802.1Q standards documentation, which is not supplied with this
device.
join timer_value Sets the GARP join timer in centiseconds (Refer to 802.1Q
standard.)
leave timer_value Sets the GARP leave timer in centiseconds (Refer to
802.1Q standard.)
leaveall
timer_value
Sets the GARP leaveall timer in centiseconds (Refer to
802.1Q standard.)
port-string Specifies the port(s) on which to configure GARP timer
settings. For a detailed description of possible port-string
values, refer to Section 4.1.2.
Matrix>set garp timer join 100
To Next Page
Loading...