VLAN Configuration Command Set
Configuring the VLAN Egress List
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-23
7.3.4.6 set vlan dynamicegress
Use this command to set the administrative status of the VLAN’s dynamic capability. If VLAN
dynamic egress is enabled, the device will add the port receiving a tagged frame to the VLAN egress
list of the port according to the frame VLAN ID. If the VLAN does not exist, it is created.
set vlan dynamicegress vlan-id {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the dynamic egress function on VLAN 7:
vlan-id Specifies the number of the VLAN on which to enable or
disable dynamic egress.
enable | disable Enables or disables dynamic egress.
Matrix>set vlan dynamicegress 7 enable
To Next Page
Loading...