Enterasys 1G58x-09 - Cls (Clear Screen); Exit

General Configuration Command Set
Pausing, Clearing and Closing the CLI
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-85
3.2.7.2 cls (clear screen)
Use this command to clear the screen for the current CLI session.
cls
Syntax Description
None
.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to clear the CLI screen:
3.2.7.3 exit
Use this command to leave a CLI session when operating in switch mode.
exit
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Matrix>cls
NOTE: Device timeout occurs after five minutes of user inactivity, automatically closing
your CLI session.
When operating in router mode, the exit command jumps to a lower configuration level.
For details on enabling router configuration modes, refer to Section 3.3.3.