SNMP Command Set
Configuring SNMP Notification Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-47
5.2.7 Configuring SNMP Notification Parameters
Purpose
To configure SNMP notification parameters and optional filters. Notifications are entities which
handle the generation of SNMP v1 and v2 “traps” or SNMP v3 “informs” messages to select
management targets. Optional notification filters identify which targets should not receive
notifications. For a sample SNMP trap configuration showing how SNMP notification parameters
are associated with security and authorization criteria (target parameters) and mapped to a
management target address, refer to Section 5.2.8.
Commands
The commands needed to configure SNMP notification parameters and filters are listed below and
described in the associated section as shown.
• show trap (Section 5.2.7.1)
• set trap (Section 5.2.7.2)
• clear trap (Section 5.2.7.3)
• show newaddrtrap (Section 5.2.7.4)
• set newaddrtrap (Section 5.2.7.5)
• show snmp notify (Section 5.2.7.6)
• set snmp notify (Section 5.2.7.7)
• clear snmp notify (Section 5.2.7.8)
• show snmp notifyfilter (Section 5.2.7.9)
• set snmp notifyfilter (Section 5.2.7.10)
• clear snmp notifyfilter (Section 5.2.7.11)
• show snmp notifyprofile (Section 5.2.7.12)
• set snmp notifyprofile (Section 5.2.7.13)
• clear snmp notifyprofile (Section 5.2.7.14)
To Next Page
Loading...
Need help?
General