Enterasys 1G58x-09 - Clear Snmp Targetparams

SNMP Command Set
Configuring SNMP Target Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-41
5.2.5.3 clear snmp targetparams
Use this command to delete an SNMP target parameter configuration.
clear snmp targetparams targetparams
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear SNMP target parameters named “v1ExampleParams”:
targetparams Specifies the name of the parameter in the SNMP target
parameters table to be cleared.
Matrix>clear snmp targetparams v1ExampleParams