SNMP Command Set
Configuring SNMP Notification Parameters
5-60 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
5.2.7.13 set snmp notifyprofile
Use this command to create an SNMP notify filter profile configuration. This associates a
notification filter, created with the set snmp notifyfilter command (Section 5.2.7.10), to a set of
SNMP target parameters to determine which management targets should not receive SNMP
notifications.
set snmp notifyprofile profile targetparam targetparam [volatile | nonvolatile]
Syntax Description
Command Defaults
If storage type is not specified, nonvolatile will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create an SNMP notify profile named area51
and associate a target
parameters entry.
5.2.7.14 clear snmp notifyprofile
Use this command to delete an SNMP notify profile configuration.
clear snmp notifyprofile profile targetparam targetparam
profile Specifies an SNMP filter notify name.
targetparam
targetparam
Specifies an associated entry in the SNMP Target Params
Table.
volatile |
nonvolatile
(Optional) Specifies a storage type.
Matrix>set snmp notifyprofile area51 targetparam v3ExampleParams
To Next Page
Loading...