EasyManuals Logo

Enterasys 1G58x-09 User Manual

Enterasys 1G58x-09
808 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #598 background imageLoading...
Page #598 background image
Process Overview: Routing Protocol Configuration
Configuring RIP
13-4 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
None.
Command Syntax of the “no” Form
The “no” form of this command disables RIP:
no router rip
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router(config)#
Command Defaults
None.
Example
This example shows how to enable RIP:
13.1.1.2 network
Use this command to attach a network of directly connected networks to a RIP routing process, or
to remove a network from a RIP routing process.
network ip_address
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command removes the network from the RIP routing
process:
no network ip_address
Matrix>Router#configure terminal
Matrix>Router(config)#router rip
Matrix>Router(config-router)#
ip_address Specifies the IP address of a directly connected network that
RIP will advertise to its neighboring routers.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys 1G58x-09 and is the answer not in the manual?

Enterasys 1G58x-09 Specifications

General IconGeneral
BrandEnterasys
Model1G58x-09
CategoryNetwork Hardware
LanguageEnglish