Security Configuration Command Set
Configuring Secure Shell (SSH)
14-86 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
14.3.6.9 set ssh rekeyintervalseconds
Use this command to set the number of seconds between SSH key exchanges.
set ssh rekeyintervalseconds value
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to set the SSH re-key interval to 7200 (2 hours):
14.3.6.10set ssh passwordguesses
Use this command to set the number of SSH authentication attempts allowed before access is
denied.
set ssh passwordguesses value
Syntax Description
Command Type
Switch command.
value Specifies the interval (in seconds) between SSH key
exchanges. Valid values are from 0 (which disables
re-keying) to 86400. Default is 3600.
Matrix>set ssh rekeyinterval 7200
value Specifies the number of authentication attempts allowed
before remote access is denied. Valid values are from 1 to
10. Default is 3.
To Next Page
Loading...
Need help?
General