Enterasys 1G58x-09 - Set Nodealias Maxentries

Logging and Network Management Command Set
Configuring Node Aliases
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-71
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable the node alias agent on Fast Ethernet front panel port 3
:
11.2.5.4 set nodealias maxentries
Use this command to set the maximum number of node alias entries allowed for one or more ports.
set nodealias maxentries val port-string
Syntax Description
Command Defaults
None.
enable | disable Enables or disables a node alias agent.
port-string Specifies the port(s) on which to enable or disable a node
alias agent. For a detailed description of possible
port-string values, refer to Section 4.1.2.
Matrix>set nodealias disable fe.0.3
val Specifies the maximum number of alias entries. Valid
values are 1 - 4096.
port-string Specifies the port(s) on which to set the maximum entry
value. For a detailed description of possible port-string
values, refer to Section 4.1.2.