Logging and Network Management Command Set
Configuring System Logging
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-21
Command Defaults
If file is not specified, the latest 200 Syslog messages stored in the audit-trail log
will be displayed.
Command Type
Switch command.
Command Mode
Super User.
Example
This example shows an excerpt of the output from the show logging audit-trail command:
11.2.1.15copy audit-trail
Use this command to copy the Syslog audit trail history buffer to a target file.
copy audit-trail destination
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>show logging audit-trail
132 <5>Apr 7 14:14:07.48 10.1.130.14 rtrFE
[HOST_DISP_](host)Bad Source Address
detect from interface vlan 3 with a source address of 127.0.2.3 destined to 10.1
.129.78, Packet Dropped
destination Specifies the target file where the Syslog audit trail will be
copied. This can be a local file in NVRAM or a file on a
TFTP server.
To Next Page
Loading...