IP Configuration Command Set
Configuring Broadcast Settings
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 12-23
Example
This example shows how to enable IP directed broadcasts on VLAN 1:
12.2.4.2 ip forward-protocol
Use this command to enable UDP broadcast forwarding and specify which protocols will be
forwarded. This command works in conjunction with the ip helper-address command to configure
UDP broadcast forwarding. For information on specifying a new destination for UDP broadcasts,
refer to Section 12.2.4.3.
ip forward-protocol {udp [port]}
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip directed-broadcast
To Next Page
Loading...