EasyManuals Logo

Enterasys 1G58x-09 User Manual

Enterasys 1G58x-09
808 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #657 background imageLoading...
Page #657 background image
Process Overview: Routing Protocol Configuration
Configuring DVMRP
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-63
13.1.3 Configuring DVMRP
Purpose
To enable and configure the Distance Vector Routing Protocol (DVMRP) on an interface. DVMRP
routes multicast traffic using a technique known as Reverse Path Forwarding. When a router
receives a packet, it floods the packet out of all paths except the one that leads back to the packet’s
source. Doing so allows a data stream to reach all VLANs (possibly multiple times). If a router is
attached to a set of VLANs that do not want to receive from a particular multicast group, the router
can send a “prune” message back up the distribution tree to stop subsequent packets from traveling
where there are no members. DVMRP will periodically reflood in order to reach any new hosts that
want to receive from a particular group.
Commands
The commands needed to enable and configure DVMRP are listed below and described in the
associated section as shown:
ip dvmrp (Section 13.1.3.1)
ip dvmrp metric (Section 13.1.3.2)
show ip dvmrp route (Section 13.1.3.3)
show ip mroute (Section 13.1.3.4)
13.1.3.1 ip dvmrp
Use this command to enable or disable DVMRP on an interface.
ip dvmrp
Syntax Description
None.
Command Syntax of the “no” Form
The “no” form of this command disables DVMRP:
no ip dvmrp
Command Type
Router command.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys 1G58x-09 and is the answer not in the manual?

Enterasys 1G58x-09 Specifications

General IconGeneral
BrandEnterasys
Model1G58x-09
CategoryNetwork Hardware
LanguageEnglish