General Configuration Command Set
Setting Basic Device Properties
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-45
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set a daylight savings time start date of April 4, 2004 at 2 a.m. and an
ending date of October 31, 2004 at 2 a.m. with an offset time of one hour:
3.2.2.19 set summertime recurring
Use this command to configure recurring daylight savings time settings. These settings will start
and stop daylight savings time at the specified day of the month and hour each year and will not
have to be reset annually.
set summertime recurring start_week start_day start_month start_hr_min
end_week end_day end_month end_hr_min [offset_minutes]
Matrix>set summertime date April 4 2004 02:00 October 31 2004 02:00 60
To Next Page
Loading...
Need help?
General