Enterasys 1G58x-09 - Clear Lacp Static

Port Configuration Command Set
Configuring Link Aggregation
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 4-65
Command Mode
Read-Write.
Example
This example shows how to add Fast Ethernet front panel ports 1 through 4 to the LAG of
aggregator port 1. As noted above, other ports cannot attach to lag.0.1 until this static LAG is
cleared:
4.3.13.3 clear lacp static
Use this command to remove specific ports from a Link Aggregation Group.
clear lacp static lagportstring port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to remove Fast Ethernet front panel port 6 from a static assignment:
Matrix>set lacp static lag.0.1 fe.0.1-4
lagportstring Specifies the LAG aggregator port from which ports will
be removed.
port-string Specifies the port(s) to remove from the LAG. For a
detailed description of possible port-string values, refer
to Section 4.1.2.
Matrix>clear lacp static lag.0.1 fe.0.6