Enterasys 1G58x-09 - Set Vlan Classification Ingress

VLAN Configuration Command Set
Assigning VLANs According to Classification Rules
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-35
Command Alternative (v2.05.xx and higher)
clear policy class (Section 8.3.2.4)
Example
This example shows how to clear the Ethernet II Type IP classification rule associated with
VLAN 7:
7.3.5.6 set vlan classification ingress
Use this command to add ports to a VLAN classification rule. Ports added will now be active for
this rule. Untagged frames received will be tagged according to the VLAN classification rule.
set vlan classification ingress vlan-id port-string data_meaning data_value
[data_mask]
Syntax Description
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to Table 7-2.
Matrix>clear vlan classification 7 ethernet-II-type ip
vlan-id Specifies the number of the VLAN that will be associated
with the new classification.
port-string Specifies the port(s) to add to the new classification rule.
For a detailed description of possible port-string values,
refer to Section 4.1.2.
data_meaning Specifies the data_meaning for the parameter used to
classify or filter frames. Refer to Table 7-1 and Table 7-2
for lists of the data_meanings and associated protocol
types and classifications.
data _value Specifies the code of a predefined classifier. The range of
values is dependent on the data_meaning. Refer to
Table 7-1 and Table 7-2 for the limitations.
data_mask (Not required for most data values.) This entry is
dependent on the data_value entered. For details, refer to
Table 7-2.