IGMP Configuration Command Set
Setting IGMP Query Interval and Response Time
10-6 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to display the IGMP response time (in tenths of a second):
10.2.2.4 set igmp response-time
Use this command to set the maximum IGMP query response time as defined in RFC 2236,
Section 8.3.
set igmp response-time value
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the IGMP response time to 200 tenths of a second:
Matrix>show igmp response-time
IGMP response time is 100 .1 seconds.
value Specifies the maximum query response time. Valid
values are 10 to 255 tenths of a second.
Matrix>set igmp response-time 200
To Next Page
Loading...