Port Configuration Command Set
Reviewing Port Status
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 4-9
4.3.1.2 show port counters
Use this command to display counter statistics detailing traffic through the switch and through all
MIB2 network devices.
show port counters [port-string] [mib2 | switch]
Syntax Description
Command Defaults
If port-string is not specified, counter statistics will be displayed for all ports. If
mib2 or switch is not specified, all counter statistics will be displayed for the
specified port(s).
Command Type
Switch command.
Command Mode
Read-Only.
Flow Ctrl Whether flow control status is enabled, disabled, or N/A
(auto negotiation is enabled).
Type Port type as:
• 10/100TX: 10Base-T/100Base-T
• 100FX: 100Base-FX
• 1000SX: 1000Base-SX
• 1000LX: 1000Base-LX
port-string (Optional) Displays counter statistics for specific port(s).
For a detailed description of possible port-string values,
refer to Section 4.1.2.
mib2 | switch (Optional) Displays MIB2 or switch statistics. Switch
statistics detail performance of the Matrix E1 switch
device. MIB2 interface statistics detail performance of all
network devices.
Table 4-2 show port status Output Details
Output What It Displays...
To Next Page
Loading...
Need help?
General