Enterasys 1G58x-09 - SNMP Command Set; Disabling; Enabling and Reviewing SNMP Statistics; Show Snmp

SNMP Command Set
Disabling / Enabling and Reviewing SNMP Statistics
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-5
5.2 SNMP COMMAND SET
5.2.1 Disabling / Enabling and Reviewing SNMP Statistics
Purpose
To disable, re-enable SNMP and to review SNMP statistics.
Commands
The commands needed to disable or enable SNMP and review SNMP statistics are listed below and
described in the associated section as shown.
• show snmp (Section 5.2.1.1)
• set snmp (Section 5.2.1.2)
• show snmp engineid (Section 5.2.1.3)
• show snmp counters (Section 5.2.1.4)
5.2.1.1 show snmp
Use this command to display the status of SNMP management on the device. By default, it is
enabled at device startup.
show snmp
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.