Enterasys 1G58x-09 - Show Snmp Notify

SNMP Command Set
Configuring SNMP Notification Parameters
5-52 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Mode
Read-Write.
Example
This example shows how to enable the new MAC address trap function on port ge.0.3:
5.2.7.6 show snmp notify
Use this command to display the SNMP notify configuration, which determines which
management targets will receive SNMP notifications.
show snmp notify [notify]
Syntax Description
Command Defaults
If a notify name is not specified, all entries will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Matrix>set newaddrtrap ge.0.3 enable
notify (Optional) Displays notify entries for a specific notify
name.