Enterasys 1G58x-09 - Clear Logging Default; Show Logging Application

Logging and Network Management Command Set
Configuring System Logging
11-14 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2.1.10clear logging default
Use this command to reset logging default values.
clear logging default [facility] [severity] [port]
Syntax Description
Command Defaults
If no parameters are specified, all logging default values will be reset.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This command shows how to reset the Syslog default severity level to 5:
11.2.1.11show logging application
Use this command to display the severity level of Syslog messages for applications.
show logging application
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
facility (Optional) Resets the default facility name to local7.
severity (Optional) Resets the default logging severity level to 5
(warning conditions).
port (Optional) Resets the default UDP port the client uses to
send to the server to 514.
Matrix>clear logging default severity