Logging and Network Management Command Set
Configuring System Logging
11-8 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11.2.1.4 set logging console
Use this command to set the severity level at which Syslog messages will display to the console, or
prevent Syslog messages from displaying to the console.
set logging console {severity | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This command shows how to set the console logging severity level to 3.
11.2.1.5 show logging server
Use this command to display the Syslog configuration for a particular server.
severity Specifies the severity level at which log messages will
display to the console. Valid values and corresponding
levels are:
1 - emergencies (system is unusable)
2 - alerts (immediate action required)
3 - critical conditions
4 - error conditions
5 - warning conditions
6 - notifications (significant conditions)
7 - informational messages
8 - debugging messages
disable Prevents logging messages from displaying to the
console.
Matrix>set logging console 3
To Next Page
Loading...
Need help?
General