EasyManuals Logo

Enterasys 1G58x-09 User Manual

Enterasys 1G58x-09
808 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
General Configuration Command Set
Setting Basic Device Properties
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-37
3.2.2.9 show version
Use this command to display hardware and firmware information. Refer to Section 3.2.3 for
instructions on how to download a firmware image. If a firmware image has been downloaded to
the switch since the last reboot, a message will be displayed indicating that fact. If no download has
taken place, no message will be displayed.
show version
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display version information. This example illustrates the message that
is displayed if a firmware image has been downloaded to the switch since the last reboot.
Table 3-5 provides an explanation of the command output.
Matrix>show version
Boot Prom Version: 01.01.00
Slot Ports Model Serial Number HW Version FW Version
---- ----- --------- ------------- ---------- -----------
0 48 1H582-51 03032222210N 0 03.04.04
1 8 1H-8FX N/A N/A N/A
2 2 1G-2TX N/A N/A N/A
3 2 1G-2GBIC N/A N/A N/A
Note: Image file firmware/images/03_05_06.fls has been downloaded
and will take effect on next reset.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys 1G58x-09 and is the answer not in the manual?

Enterasys 1G58x-09 Specifications

General IconGeneral
BrandEnterasys
Model1G58x-09
CategoryNetwork Hardware
LanguageEnglish