Enterasys 1G58x-09 - Ip Irdp Maxadvertinterval

Process Overview: Routing Protocol Configuration
Configuring IRDP
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-69
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
This example shows how to enable IRDP on VLAN 1:
13.1.4.2 ip irdp maxadvertinterval
Use this command to set the maximum interval in seconds between IRDP advertisements.
ip irdp maxadvertinterval interval
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the maximum advertisement interval to the
default value of 600 seconds:
no irdp maxadvertinterval
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip irdp
interval Specifies a maximum advertisement interval in seconds.
Valid values are 4 to 1800.