Logging and Network Management Command Set
Configuring Node Aliases
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-69
11.2.5.2 show nodealias config
Use this command to display node alias configuration settings on one or more ports.
show nodealias config [port-string]
Syntax Description
Command Defaults
If port-string is not specified, node alias configurations will be displayed for all
ports.
Command Mode
Read-Only.
Example
This example shows how to display node alias configuration settings for all Gigabit Ethernet ports:
Table 11-8 provides an explanation of the command output.
port-string (Optional) Displays node alias configuration settings for
specific port(s). For a detailed description of possible
port-string values, refer to Section 4.1.2.
Matrix>show nodealias config ge.*.*
Total Control Entries = 11 Active Entries = 11
Purge Time = 0 days 00:00:00 State = Ready
Allocated Entries = 4092 Available Entries = 4
Port Number Max Entries Used Entries Status
----------- ----------- ------------ --------
ge.0.1 682 0 Enabled
ge.0.2 682 0 Enabled
ge.0.3 682 0 Enabled
ge.0.4 682 0 Enabled
ge.0.5 682 0 Enabled
ge.0.6 682 11 Enabled
To Next Page
Loading...