SNMP Command Set
Configuring SNMP MIB Views
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 5-33
5.2.4 Configuring SNMP MIB Views
Purpose
To review and configure SNMP MIB views. SNMP views map SNMP objects to access rights.
Commands
The commands needed to review and configure SNMP MIB views are listed below and described
in the associated section as shown.
• show snmp view (Section 5.2.4.1)
• set snmp view (Section 5.2.4.2)
• clear snmp view (Section 5.2.4.3)
5.2.4.1 show snmp view
Use this command to display the MIB configuration for SNMPv3 view-based access (VACM).
show snmp view [viewname subtree oid]]
Syntax Description
Command Defaults
If no parameters are specified, all SNMP MIB view configuration information will
be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
viewname subtree
oid
(Optional) Displays information for a specific MIB view
and subtree.
To Next Page
Loading...
Need help?
General