SNMP Command Set
Configuring SNMP Notification Parameters
5-50 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Type
Switch command.
Command Mode
Read-Write
Example
This example shows how to clear the trap assigned to IP address 172.29.65.123:
5.2.7.4 show newaddrtrap
Use this command to display the status of the SNMP new MAC addresses trap function on one or
more ports.
show newaddrtrap [port-string]
Syntax Description
Command Defaults
If port-string is not specified, the status of the new MAC addresses trap function
will be displayed for all ports.
Command Mode
Read-Only.
Matrix>clear trap 172.29.65.123
port-string (Optional) Displays the status of the new MAC addresses
trap function on specific port(s). For a detailed description
of possible port-string values, refer to Section 4.1.2.
To Next Page
Loading...