Logging and Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-63
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the SNTP poll interval to 30 seconds
:
11.2.4.5 set sntp server
Use this command to add a server from which the SNTP client will retrieve the current time when
operating in unicast mode. Up to 10 servers can be set as SNTP servers.
set sntp server {ip-address | hostname}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
interval Specifies the poll interval in seconds. Valid values are 16 to
16284.
Matrix>set sntp poll-interval 30
ip-address |
hostname
Specifies the SNTP server’s IP address or host name.
To Next Page
Loading...