Enterasys 1G58x-09 - Port String Syntax Used in the CLI

Port Configuration Summary
Port String Syntax Used in the CLI
4-4 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4.1.2 Port String Syntax Used in the CLI
Commands requiring a port-string parameter use the following syntax to designate port type and
location:
port type.slot location.port number
Where port type can be:
fe, for Fast Ethernet; or
ge, for 1-Gigabit Ethernet
lag, for Link Aggregator
lbpk, for loopback interfaces
host, for the host (management) port
Slot location can be:
0, for the fixed front panel slot,
1, for left expansion module slot (in the 1H582-51 and 1G58x-09
devices), or the single expansion
module slot (in the 1H582-25 device
)
2, for middle expansion module slot, or
3, for right expansion module slot
Port number can be:
Any port number in a slot location.
The highest port number that can be entered is dependent on the number of ports in a slot location.
1G-2MGBIC 1000BASE-SX Two slots for optional Mini-GBICs
(Mini-GBICs have 1 MT-RJ
connector)
| 1 | 2 |
1H-8FX 100BASE-FX Eight fixed MT-RJ connectors
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
Table 4-1 Ethernet Expansion Module Interface Types and Port Numbering (Continued)
Ethernet expansion module Interface Type Port Numbering