IGMP Configuration Command Set
Configuring IGMP VLAN Registration
10-10 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display IVR information for front panel Fast Ethernet ports 1 through 3:
Table 10-2 provides details of the command output.
10.2.4.2 set igmp mode vlan
Use this command to set the VLAN registered to forward multicast traffic to all subscribing, or
“open” ports.
set igmp mode vlan vlan_id
Matrix>show igmp mode fe.0.1-3
IGMP MODE VLAN: 1
IGMP MODE IP: 10.1.2.3
Port Mode Port Mode Port Mode
------------------------------------------------------------
fe.0.1 open fe.0.2 open fe.0.3 open
Table 10-2 show igmp mode Output Details
Output What It Displays...
IGMP MODE
VLAN
VLAN segment to be used by all ports running in IGMP
open mode.
IGMP MODE IP Virtual IP address associated with the VLAN ID through
which all multicast traffic is forwarded.
Port Port designation.
Type
Whether or not the port’s IVR registration is:
• Open — scoping multicast transmissions to the IGMP
VLAN. These ports are user access ports subscribing to
receive multicast streams via the IGMP registered VLAN.
• Secure — scoping multicast transmissions to the VLAN
receiving the IGMP requests.
To Next Page
Loading...
Need help?
General