VLAN Configuration Command Set
Configuring the VLAN Egress List
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-19
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows you how to set Fast Ethernet port 3 to forbidden for VLAN 6:
7.3.4.2 show port egress
Use this command to display the VLAN membership for one or more ports.
show port egress [port-string]
Syntax Description
Command Defaults
If port-string is not specified, VLAN membership will be displayed for all ports.
Command Type
Switch command.
Command Mode
Read-Write.
vlan-id Specifies the VLAN for which to set forbidden port(s).
port-string Specifies the port(s) to set as forbidden for the specified
vlan-id. For a detailed description of possible port-string
values, refer to Section 4.1.2.
Matrix>set vlan forbidden 6 fe.0.3
port-string (Optional) Displays VLAN membership for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.2.
To Next Page
Loading...