Port Configuration Command Set
Setting Flow Control and Thesholds
4-34 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
This example shows how to set the receive buffer and the flow control on and off limit buffers
within the IngressRX threshold for frames destined for Gigabit Ethernet ports:
This example shows how to reset all port threshold buffers to default values:
4.3.6.5 show flow agetime
Use this command to display the flow age time setting. This is the amount of time in seconds until
a flow control entry will be removed if no activity has occurred on the flow.
show flow agetime
Syntax Description
None.
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
None.
Example
This example shows how to display the flow age time setting:
Matrix>set port buffer threshold ingressrx ge 30.0 20.0 25.0
Matrix>set port buffer threshold resetall
Matrix>show flow agetime
Flow age time: 30
To Next Page
Loading...
Need help?
General