Logging and Network Management Command Set
Managing Switch Network Addresses
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-37
Syntax Description
Command Defaults
If hostname or ip_address are not specified, all ARP entries will be cleared.
Command Mode
Read-Write.
Example
This example shows how to delete entry 10.1.10.10 from the ARP table:
11.2.3.4 show rad
Use this command to display the status of the RAD (Runtime Address Discovery) protocol on the
switch.
show rad
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display RAD status:
hostname |
ip_address
(Optional) Specifies the IP address in the ARP table to be
cleared. An IP alias or host name that can be resolved through
the DNS can be specified instead of an IP address.
Matrix>clear arp 10.1.10.10
Matrix>show rad
RAD is currently enabled.
To Next Page
Loading...
Need help?
General