Enterasys 1G58x-09 - Set Port Trap

Port Configuration Command Set
Setting Port Traps
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 4-41
4.3.7.2 set port trap
Use this command to enable or disable an SNMP link trap on one or more ports.
set port trap port-string {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable the SNMP link trap for Fast Ethernet front panel port 3:
port-string Specifies the port(s) for which to enable or disable a trap.
For a detailed description of possible port-string values,
refer to Section 4.1.2.
enable | disable Enables or disables a trap on the specified port.
Matrix>set port trap fe.0.3 disable