Logging and Network Management Command Set
Configuring Node Aliases
11-72 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the maximum node alias entries to 1000 on Fast Ethernet front panel
port 3
:
11.2.5.5 clear nodealias
Use this command to remove one or more node alias entries.
clear nodealias {port port-string | alias-id alias-id}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear all node alias entries on Fast Ethernet front panel port 3
:
Matrix>set nodealias maxentries 1000 fe.0.3
port port-string Specifies the port(s) on which to remove all node alias
entries. For a detailed description of possible port-string
values, refer to Section 4.1.2.
alias-id alias-id Specifies the ID of the node alias to remove. This value can
be viewed using the show nodealias command as described
in Section 11.2.5.1.
Matrix>clear nodealias port fe.0.3
To Next Page
Loading...