Enterasys 1G58x-09 - Clear Vlan Classification

VLAN Configuration Command Set
Assigning VLANs According to Classification Rules
7-34 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
7.3.5.5 clear vlan classification
Use this command to clear a VLAN classification entry.
clear vlan classification vlan-id data_meaning data _value [data_mask]
Syntax Description
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to Table 7-2.
Command Type
Switch command.
Command Mode
Read-Write.
IPX Class of Service 8
IPX Type 9
Protocol Type (Ether Type or DSAP/SSAP) 10
Receive Port 11
vlan-id Specifies the number of the VLAN associated with the
classification to be cleared.
data_meaning Specifies the data_meaning of the classification to be
cleared. Refer to Table 7-1 and Table 7-2 for lists of the
data_meanings and associated protocol types and
classifications.
data _value Specifies the data_value of the classification to be cleared.
The range of values is dependent on the data_meaning.
Refer to Table 7-1 and Table 7-2 for the limitations.
data_mask (Not required for most data values.) This entry is dependent
on the data_value entered. For details, refer to Table 7-2.
Table 7-3 Classification Precedence (Continued)