VLAN Configuration Command Set
Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
7-14 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Mode
Read-Only.
Example
This example shows how to display port VLAN lists for Fast Ethernet front panel ports 1 through
5. It shows they are on the port VLAN list of VLAN 1:
7.3.3.2 set port vlan
Use this command to configure the PVID (port VLAN identifier) for one or more ports.
set port vlan port-string vlan-id
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Matrix>show port vlan fe.0.1-5
Port fe.0.1 has a port VLAN ID of 1.
Port fe.0.2 has a port VLAN ID of 1.
Port fe.0.3 has a port VLAN ID of 1.
Port fe.0.4 has a port VLAN ID of 1.
Port fe.0.5 has a port VLAN ID of 1.
NOTE: The PVID is used to classify untagged frames as they ingress into a given port.
When setting a PVID with the set port vlan command, you can also add the port to the
VLAN’s untagged egress list.
port-string Specifies the port(s) for which to configure a VLAN
identifier. For a detailed description of possible port-string
values, refer to Section 4.1.2.
vlan-id Specifies the VLAN to which port(s) will be added.
To Next Page
Loading...