Port Configuration Command Set
Setting Flow Control and Thesholds
4-28 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
• show flow agetime (Section 4.3.6.5)
• set flow agetime (Section 4.3.6.6)
• clear flow agetime (Section 4.3.6.7)
• show port holbp (Section 4.3.6.8)
• set port holbp (Section 4.3.6.9)
4.3.6.1 show port flowcontrol
Use this command to display the flow control state for one or more ports.
show port flowcontrol [port-string]
Syntax Description
Command Defaults
If port-string is not specified, flow control statistics for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the port flow control state for Fast Ethernet front panel ports
15 through 18. It shows that auto-negotiation is enabled on ports 15 and 18 (therefore, flow control
cannot be enabled on these ports). It also shows that flow control is disabled on port 16, and enabled
on port 17:
port-string (Optional) Displays flow control state for specific port(s).
For a detailed description of possible port-string values,
refer to Section 4.1.2.
Matrix>show port flowcontrol fe.0.15-18
Port fe.0.15 flow control state is auto negotiate.
Port fe.0.16 flow control state is disabled.
Port fe.0.17 flow control state is enabled.
Port fe.0.18 flow control state is auto negotiate.
To Next Page
Loading...
Need help?
General