Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 12-1
12
IP Configuration
This chapter describes the Internet Protocol (IP) configuration set of commands and how to use
them.
12.1 PROCESS OVERVIEW: INTERNET PROTOCOL (IP)
CONFIGURATION
Use the following steps as a guide to configuring IP on the device:
1. Configuring routing interface settings (Section 12.2.3)
2. Reviewing and saving the routing configuration (Section 12.2.2)
3. Reviewing and configuring the ARP table (Section 12.2.3)
4. Reviewing and configuring broadcast settings (Section 12.2.4)
5. Reviewing IP traffic and configuring routes (Section 12.2.5)
ROUTER: The commands covered in this chapter can be executed when the device is
in router mode only. For details on how to enable router configuration modes, refer to
Section 3.3.3.
To Next Page
Loading...