Enterasys 1G58x-09 - Set Pwa Initialize; Set Pwa Quietperiod

Security Configuration Command Set
Configuring Port Web Authentication (PWA)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-75
14.3.5.13set pwa initialize
Use this command to initialize a PWA port to its default unauthenticated state.
set pwa initialize [port-string]
Syntax Description
Command Defaults
If port-string is not specified, all ports will be initialized.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to initialize Fast Ethernet front panel ports 5-7:
14.3.5.14set pwa quietperiod
Use this command to set the amount of time a port will remain in the held state after a user
unsuccessfully attempts to log on to the network.
set pwa quietperiod time [port-string]
Syntax Description
Command Defaults
If port-string is not specified, quiet period will be set for all ports.
port-string (Optional) Initializes specific port(s). For a detailed
description of possible port-string values, refer to
Section 4.1.2.
Matrix>set pwa initialize fe.0.5-7
time Specifies quiet time in seconds.
port-string (Optional) Sets the quiet period for specific port(s). For a
detailed description of possible port-string values, refer
to Section 4.1.2.