Process Overview: Routing Protocol Configuration
Configuring OSPF
13-48 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Type
Router command.
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Example
This example shows how enable passive OSPF mode on VLAN 102:
13.1.2.21redistribute
Use this command to allow routing information discovered through non-OSPF protocols to be
distributed in OSPF update messages.
redistribute {connected | rip | static}[metric metric value] [metric-type
type-value] [subnets]
Matrix>Router(config)#router ospf 1
Matrix>Router(config-router)#passive-ospf vlan 102
To Next Page
Loading...
Need help?
General